Responsibility and duties:

Oversee inspection of steel structural pre-fabrication and installation activities conducted at contractors / sub-contractors facilities and at site

Assist in structural material receiving inspections at site and review original material certificates for compliance to codes and specifications where required

Ensure traceability is maintained for the fabricated part as stated in the project specifications

Monitor and ensure the inspections are carried out to the required levels as mentioned in the ITPs

Witness the dimensional control inspections on the pre-fabricated and as well on the installed parts

Co-ordinate with other disciplines for interface activities, for example civil foundation interface with structural

Monitor the structural welding activities inclusive of fit up / dimensional control inspections

Monitor the contractor uses only qualified welders and follows the approved welding procedures

Witness NDT / review NDT reports as required

Final inspection, generate punch lists and follow up of the same for close out

Verify Contractor, Subcontractor Quality management systems, plans, procedures, and processes are in place.  Implement Cepu project Construction Surveillance Program.

Inspect / assist in monitoring structural painting activities

Witness bolt torque tightening of structural components

Monitor quality, issue non-conformance reports when quality deficiencies are noted and set in motion the corrective actions jointly with contractor.  Maintain the NCR data base for structural portion.

Prepare weekly or monthly quality reports to be submitted to Site verification lead.

Required knowledge, qualifications, skills, and experiences:

S 1 or equivalent with minimum 10 years of experience out of which at least 5 years working in an oil and gas on shore plant construction project as senior structural inspector. Qualifications in welding inspection preferred.

Familiar with international standards like ASCI, AWS D1.1 etc. and industrial practices on structural fabrication and installation inspection works.

Knowledgeable on welding, NDT and painting activities and associated inspection.

Familiar with structural dimensional checking using conventional and digital survey instruments.

Able to understand and interpret Civil survey reports for co-ordinates / leveling / orientation.

Understand torque tightening methods and inspection.

Good interpersonal communication skills with fluency in Bahasa Indonesia and English.

Computer literate familiar with MS Office suite for preparing official reports.

Placement : Batam